Genie Z-25J Manual do Utilizador Página 36

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 59
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 35
Operator's Manual Fourth Edition · First Printing
34 Z-45/25 • Z-45/25J Part No. 114339
Inspections
Test the Oscillate Axle
(oscillating axle-equipped models)
46 Start the engine from the platform controls.
47 Drive the right steer tire up onto a 6 inch /
15 cm block or curb.
Result: The three remaining tires should stay in
firm contact with the ground.
48 Drive the left steer tire up onto a 6 inch /
15 cm block or curb.
Result: The three remaining tires should stay in
firm contact with the ground.
49 Drive both steer tires up onto a 6 inch /
15 cm block or curb.
Result: The non-steer tires should stay in firm
contact with the ground.
Test Auxiliary Controls
50 Shut the engine off.
51 Pull out the red Emergency Stop button to
the on position.
52 Press down the foot switch.
53 Simultaneously hold the auxiliary power switch
on and activate each function control handle or
toggle switch.
Note: To conserve battery power, test each
function through a partial cycle.
Result: All boom and steer functions should
operate. Drive functions should not operate with
auxiliary power.
Test the Lift/Drive Select Function
(if equipped)
54 Press down the foot switch.
55 Move the drive control handle off center and
activate a boom function toggle switch.
Result: No boom functions should operate. The
machine will move in the direction indicated on
the control panel.
56 Repair any malfunctions before operating the
machine.
Test Aircraft Protection Package (if equipped)
57 Move the gray bumper at the bottom of the
platform 4 inches / 10 cm in any direction.
58 Activate each function control handle or toggle
switch.
Result: All boom and steer functions should not
operate.
59 Move the function override switch to either side.
60 Activate each function control handle or toggle
switch.
Result: All boom and steer functions should
operate.
Vista de página 35
1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 58 59

Comentários a estes Manuais

Sem comentários